1-1. Installation

The LCD module is installed using the mounting holes on the PCB to the equipment and instruments used. Because the display screen inside the module is composed of two very thin pieces of glass, it is easy to damage, so special care should be taken when installing the application.

1-2. Cleaning the module

When cleaning the module, use a soft cloth dipped in a small amount of solvent (recommended below) and wipe gently.

-Isopropyl alcohol

-Ethanol

Avoid scrubbing the display surface with dry or hard objects to avoid damaging the polarizer.

Do not use the following solvents:

-Water

-Ketones

-Aromatic compounds

1-3. Prevent static electricity

The driver IC used on the LCD module is a C-MOS large-scale integrated circuit. Therefore, do not connect any unused input terminals to VDD or Vss, do not input any signal to the module before the power is turned on, and ground the operator's body, workbench, and assembly station. Install equipment to prevent static electricity.

1-4. Packaging

The LCD module avoids violent vibration or falls from a height.

To prevent the aging of the module, avoid working or storage under direct sunlight or under high temperature and high humidity environment.

1-5. Operation (Precautions)

The LCD module must be driven within the specified voltage range. Higher than the specified drive voltage will shorten the life of the LCD module.

DC current will cause the LCD to deteriorate, so avoid using DC drive.

When the temperature is lower than the operating temperature range, the response time of the LCD will be significantly longer. When the temperature is higher than the operating temperature range, the LCD color becomes darker.